Page 1 of 1

Mixture command problem while connectec with JoinFs

Posted: Tue Jan 29, 2019 5:37 pm
by Jean-Luc Alzir
Good evening Peter.
Last night we flew with Cyberavia, FSX and P3D, we used versions 1.4.24 and 1.4.23. From the beginning of the flight, several pilots noticed a problem with the mixture command. This command went to zero after one or two minutes of flight, and it was impossible to maintain this command up. The plane used was the Cessna C337 skymaster from Carenado. Once JoinFs disconnected, the problem disappeared, but started again once reconnected.
Have you ever had information about this kind of bug, and if it is related to JoinFs.
We were 12 pilots connected, and only those flying on this plane had the problem.

Re: Mixture command problem while connectec with JoinFs

Posted: Tue Jan 29, 2019 7:02 pm
by blue_ice
This thread relates to this problem viewtopic.php?f=2&t=585&p=4082&hilit=engine+cut#p4082
Its a known problem with carenado aircraft. Avoid using any Carenado aircraft for model matching, substitute for something else

From what i remember, it only takes one user to be using a Carenado for model matching and it will affect everyone flying a carenado aircraft.

regards

Darren

Re: Mixture command problem while connectec with JoinFs

Posted: Wed Jan 30, 2019 10:31 am
by Jean-Luc Alzir
Thanks a lot Darren, it works...